333体育直播免费在线平台

Recommendation: Use grease for glow plugs 134100 = Sold in Hitachi brand: printing and packaging

10g. or 134101 = 100g., see accessory lists.

Recommendation: Use grease for glow plugs 134100 = Sold in Hueco brand: printing and packaging

10g. or 134101 = 100g., see accessory lists.

Recommendation: Use grease for glow plugs 134100 = Sold in Hitachi brand: printing and packaging

10g. or 134101 = 100g., see accessory lists.

Recommendation: Use grease for glow plugs 134100 = Sold in Hitachi brand: printing and packaging

10g. or 134101 = 100g., see accessory lists.

Recommendation: Use grease for glow plugs 134100 = Sold in Hitachi brand: printing and packaging

10g. or 134101 = 100g., see accessory lists.

(Federal Emissions) (Federal Emissions) (Gear Driven) (Gear Driven) (seconds) at an Ambient Temperature of 20 Degrees Centigrade Battery Terminal Continuous Operating Current Glow Plug Terminal Ground Terminal Ignition Switch Terminal Preheat: Glow Plug & Warning Light Energized Preheat: Glow Plug & Warning Light Energized Starter Solenoid Terminal Vehicle System Voltage

(Federal Emissions) (Federal Emissions) (Gear Driven) (Gear Driven) Battery Terminal Continuous Operating Current Glow Plug Terminal Ground Terminal Ignition Switch Terminal Preheat: Glow Plug & Warning Light Energized Preheat: Glow Plug & Warning Light Energized Starter Solenoid Terminal Vehicle System Voltage

In the warranty, we always make a distinction between wear Products supplied by us are without exception intended for parts and vehicle parts. All wear parts are subject to a the designated use. Please note that our products are usually delivered without reduced warranty period and a maximum mileage.

installation instructions. Brake components such as brake disks, brake pads, etc. Installation may only be carried out by trained specialist maximum of 1000 km (break-in period). Therefore, warranty personnel. claims for brake parts are only reviewed with an There is no guarantee for inappropriate, improper or installation invoice and a record of the wheel hub run-out unintended use.

measurement, including photos.

For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed.

When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced.

If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.