333体育直播免费在线平台

Procedure of turn indicators replacement depends on the type and mounting location of the component. For the VW PASSAT Variant (3B6) car it can vary according to modification, configuration and manufacturing year of the vehicle. See the detailed algorithm in the car technical documentation.

Before starting to replace the component make sure that the problem lies exactly in it. For example, if all four indicators can not be turned on, most likely the relay or switch is broken or the fuse is burnt off.

With the help of a multimeter, check if power is supplied to the turn indicator connector. If signal is absent, contact a car electrician for diagnostics and repair.

Before starting works, be sure to disconnect the negative terminal from the battery. Short circuit can break down the automotive equipment and is dangerous for life.

Use two plastic cards to release the turn indicator retainers on the VW PASSAT Variant (3B6) car from the outside. You should insert the cards under the light, and carefully press the retainers with them from both sides simultaneously. After this, pull the light towards yourself and remove it from the mounting seat. On some modifications you need to slide the turn indicator in the direction of the car front, and pull the rear component part towards you.

In order to replace the turn indicator repeater mounted in the side mirror, there is no necessity to demount the whole assembly. Using a plastic wedge, release the mirror body retainers, and then 鈥� those of the mirror element. Access to the turn indicator repeater fasteners will be gained after this.

Install new bulbs of the turn indicators. Their lifetime is limited, so in order to avoid necessity to demount the indicator light again after a while, you鈥檇 better replace the lighting elements as well.

Before connecting the light, clean the connector from dirt and oxides, in order to provide reliable contact in the VW PASSAT Variant (3B6) car turn indicator lamp holder.

Treat the connector contacts with a special grease to protect them from oxidizing. Agents for electric contacts protection can be easily found in the assortment of all well-known auto care products manufacturers.

Activate the turn indicators and test their operation in various modes, to make sure that their replacement is performed correctly.