Vehicle identification number: 0588514
Audi 100 C4 2.0 E quattro Suspension arm (115 hp Petrol AAD)
- Control / Trailing Arm Type: Control Arm
- Fitting Position: Front Axle Left, Lower
- paired article number: 58008302
- Supplementary Article / Supplementary Info Info 2: with ball joint, with rubber mount
- Item number: 58008601
- Manufacturer: METZGER
- EAN number: 4250032430528
- Condition: New
- Control / Trailing Arm Type: Control Arm
- Supplementary Info: Original VAICO Quality
- Fitting Position: Left, Lower Front Axle
- paired article number: V10-7016
- Supplementary Article / Supplementary Info Info 2: with bearing(s)
- Weight [kg]: 3,15
- Article number of the recommended special tool: V99-1020
- Axle alignment required after fitting
- Packaging width [cm]: 11,5
- Packaging height [cm]: 8
- Packaging Depth [cm]: 45
- Item number: V10-7017
- Manufacturer: VAICO
- EAN number: 4046001186301
- Condition: New
In the warranty, we always make a distinction between wear Products supplied by us are without exception intended for parts and vehicle parts. All wear parts are subject to a the designated use. Please note that our products are usually delivered without reduced warranty period and a maximum mileage.
installation instructions. Brake components such as brake disks, brake pads, etc. Installation may only be carried out by trained specialist maximum of 1000 km (break-in period). Therefore, warranty personnel. claims for brake parts are only reviewed with an There is no guarantee for inappropriate, improper or installation invoice and a record of the wheel hub run-out unintended use.
measurement, including photos.
For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed.
When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced.
If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Control / Trailing Arm Type: Control Arm
- Material: Cast Steel
- Fitting Position: Rear Axle Upper, Right
- paired article number: 72-1632
- Supplementary Article / Supplementary Info Info 2: with nut, with ball joint, with bearing(s)
- Item number: 72-1631
- Manufacturer: MAXGEAR
- EAN number: 5907558559590
- Condition: New
- Control / Trailing Arm Type: Control Arm
- Material: Cast Steel
- Fitting Position: Rear Axle Upper, Left
- paired article number: 72-1631
- Supplementary Article / Supplementary Info Info 2: with bearing(s), with nut, with ball joint
- Item number: 72-1632
- Manufacturer: MAXGEAR
- EAN number: 5907588559606
- Condition: New
-
- Fitting Position: Front Axle Right, outer
- paired article number: TC504
- Control / Trailing Arm Type: Control Arm
- Material: Steel
- Fitting Position: Right, Lower
- Length [mm]: 454
- paired article number: TC504
- Supplementary Article / Supplementary Info Info 2: with ball joint
- Width [mm]: 450
- Item number: TC505
- Manufacturer: DELPHI
- EAN number: 5012759858813
- Condition: New
- Control / Trailing Arm Type: Control Arm
- Material: Cast Steel
- Fitting Position: Front Axle Right
- paired article number: M-S0136
- Supplementary Article / Supplementary Info Info 2: with ball joint, with bearing(s)
- Supplementary Article / Supplementary Info: with sleeve
- Item number: M-S0137
- Manufacturer: MERTZ
- EAN number: 5902701001346
- Condition: New
- Control / Trailing Arm Type: Control Arm
- Supplementary Info: COMPETENCE KIT
- Fitting Position: Rear Axle Left
- paired article number: 58006804
- Supplementary Article / Supplementary Info Info 2: with ball joint
- Item number: 58006703
- Manufacturer: METZGER
- EAN number: 4250032433741
- Condition: New
- Control / Trailing Arm Type: Control Arm
- Supplementary Info: COMPETENCE KIT
- Fitting Position: Rear Axle Right
- paired article number: 58006703
- Supplementary Article / Supplementary Info Info 2: with ball joint
- Item number: 58006804
- Manufacturer: METZGER
- EAN number: 4250032433758
- Condition: New
- Control / Trailing Arm Type: Control Arm
- Material: Cast Steel
- Diameter [mm]: 19
- Fitting Position: Front Axle Left, Lower
- paired article number: 10663
- Supplementary Article / Supplementary Info Info 2: with ball joint, with rubber mount
- Weight [kg]: 3,237
- Inner Diameter [mm]: 15
- Observe service information
- Item number: 10662
- Manufacturer: FEBI BILSTEIN
- EAN number: 4027816106623
- Condition: New
These products are designed to be used as originally These products are designed to be used as originally intended and not modified for purpose. Please ensure the intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are installed by a competent individual. N.B. products are usually supplied without fitting instructions. products are usually supplied without fitting instructions.
- Control / Trailing Arm Type: Control Arm
- Material: Cast Steel
- Fitting Position: Front Axle Left
- paired article number: M-S0137
- Supplementary Article / Supplementary Info Info 2: with ball joint, with bearing(s)
- Supplementary Article / Supplementary Info: with sleeve
- Item number: M-S0136
- Manufacturer: MERTZ
- EAN number: 5902701001339
- Condition: New
- Control / Trailing Arm Type: Control Arm
- Material: Cast Steel
- Diameter [mm]: 19
- Fitting Position: Front Axle Right, Lower
- paired article number: 10662
- Supplementary Article / Supplementary Info Info 2: with ball joint, with rubber mount
- Weight [kg]: 3,237
- Inner Diameter [mm]: 15
- Observe service information
- Item number: 10663
- Manufacturer: FEBI BILSTEIN
- EAN number: 4027816106630
- Condition: New
These products are designed to be used as originally These products are designed to be used as originally intended and not modified for purpose. Please ensure the intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are installed by a competent individual. N.B. products are usually supplied without fitting instructions. products are usually supplied without fitting instructions.
- Control / Trailing Arm Type: Control Arm
- Fitting Position: Front Axle Left, Lower
- Item number: 110048410
- Manufacturer: AUTOMEGA
- EAN number: 4053184298226
- Condition: New
- Control / Trailing Arm Type: Control Arm
- Material: Cast Steel
- Fitting Position: Front Axle Left, Lower
- paired article number: 18892
- Supplementary Article / Supplementary Info Info 2: with ball joint
- Weight [kg]: 1,340
- Supplementary Article / Supplementary Info: with sleeves, with rubber mounts
- Observe service information
- Item number: 18890
- Manufacturer: FEBI BILSTEIN
- EAN number: 4027816188902
- Condition: New
These products are designed to be used as originally These products are designed to be used as originally intended and not modified for purpose. Please ensure the intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are installed by a competent individual. N.B. products are usually supplied without fitting instructions. products are usually supplied without fitting instructions.
- Control / Trailing Arm Type: Control Arm
- Fitting Position: Rear Axle, Right
- paired article number: AU-TC-7207
- Supplementary Article / Supplementary Info Info 2: with ball joint, with rubber mount
- Packing Type: Box
- Packaging length [cm]: 34,5
- Packaging width [cm]: 8,5
- Packaging height [cm]: 6,5
- Item number: AU-TC-7219
- Manufacturer: MOOG
- EAN number: 4044197481781
- Condition: New
- Control / Trailing Arm Type: Control Arm
- Material: Cast Steel
- Fitting Position: Front Axle Right, Lower
- paired article number: 18890
- Supplementary Article / Supplementary Info Info 2: with ball joint
- Weight [kg]: 1,340
- Supplementary Article / Supplementary Info: with rubber mounts, with sleeves
- Observe service information
- Item number: 18892
- Manufacturer: FEBI BILSTEIN
- EAN number: 4027816188926
- Condition: New
These products are designed to be used as originally These products are designed to be used as originally intended and not modified for purpose. Please ensure the intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are installed by a competent individual. N.B. products are usually supplied without fitting instructions. products are usually supplied without fitting instructions.
- Control / Trailing Arm Type: Trailing Arm
- Material: Steel
- Cone Size [mm]: 16,2
- Fitting Position: Rear Axle Left
- paired article number: 46942
- Rod / Strut: Push Rod
- Drive Type: All-wheel Drive
- Observe service information
- Item number: 46941
- Manufacturer: SPIDAN CHASSIS PARTS
- EAN number: 5413978813018
- Condition: New
- Control / Trailing Arm Type: Trailing Arm
- Material: Steel
- Cone Size [mm]: 16,2
- Fitting Position: Rear Axle Right
- paired article number: 46941
- Rod / Strut: Push Rod
- Drive Type: All-wheel Drive
- Observe service information
- Item number: 46942
- Manufacturer: SPIDAN CHASSIS PARTS
- EAN number: 5413978813025
- Condition: New
- Control / Trailing Arm Type: Control Arm
- Material: Cast Steel
- Fitting Position: Rear Axle Upper, Left
- paired article number: 19762
- Supplementary Article / Supplementary Info Info 2: with ball joint, with bearing(s)
- Weight [kg]: 0,819
- Supplementary Article / Supplementary Info: with lock nut
- Observe service information
- Item number: 19760
- Manufacturer: FEBI BILSTEIN
- EAN number: 4027816197607
- Condition: New
These products are designed to be used as originally These products are designed to be used as originally intended and not modified for purpose. Please ensure the intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are installed by a competent individual. N.B. products are usually supplied without fitting instructions. products are usually supplied without fitting instructions.
- Control / Trailing Arm Type: Control Arm
- Cone Size [mm]: 19
- Fitting Position: Front Axle Left
- paired article number: 821 0347 10
- Item number: 821 0346 10
- Manufacturer: FAG
- EAN number: 4014870397784
- Condition: New
- Control / Trailing Arm Type: Control Arm
- Cone Size [mm]: 19
- Fitting Position: Front Axle Right
- paired article number: 821 0346 10
- Item number: 821 0347 10
- Manufacturer: FAG
- EAN number: 4014870419721
- Condition: New
- 1
- 2
- 3
- 4
- 5