VW Passat NMS 2.0 TDI Suspension arm (150 hp Diesel CVCA)
- Control / Trailing Arm Type: Control Arm
- Material: Sheet Steel
- Fitting Position: Rear Axle Right, Lower, Front
- paired article number: 40439
- Supplementary Article / Supplementary Info Info 2: with bolts / screws
- Weight [kg]: 1,325
- Supplementary Article / Supplementary Info: with rubber mounts, with nuts
- Observe service information
- Bolt / Nut Version: with lockwasher, with plain washer
- Item number: 40438
- Manufacturer: FEBI BILSTEIN
- EAN number: 4027816404385
- Condition: New
These products are designed to be used as originally These products are designed to be used as originally intended and not modified for purpose. Please ensure the intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are installed by a competent individual. N.B. products are usually supplied without fitting instructions. products are usually supplied without fitting instructions.
- Control / Trailing Arm Type: Trailing Arm
- Material: Sheet Steel
- Fitting Position: Rear Axle
- Article number of the recommended special tool: V99-1020
- Axle alignment required after fitting
- Packaging width [cm]: 16,7
- Packaging height [cm]: 5,2
- Packaging Depth [cm]: 36
- Item number: V10-3431
- Manufacturer: VAICO
- EAN number: 4046001652608
- Condition: New
In the warranty, we always make a distinction between wear Products supplied by us are without exception intended for parts and vehicle parts. All wear parts are subject to a the designated use. Please note that our products are usually delivered without reduced warranty period and a maximum mileage.
installation instructions. Brake components such as brake disks, brake pads, etc. Installation may only be carried out by trained specialist maximum of 1000 km (break-in period). Therefore, warranty personnel. claims for brake parts are only reviewed with an There is no guarantee for inappropriate, improper or installation invoice and a record of the wheel hub run-out unintended use.
measurement, including photos.
For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed.
When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced.
If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Control / Trailing Arm Type: Trailing Arm
- Fitting Position: Rear Axle
- Weight [kg]: 0,722
- Model Year to: 2015
- Packaging length [cm]: 35,5
- Packaging width [cm]: 6,2
- Packaging height [cm]: 6,0
- Item number: 2325-B7LOWR
- Manufacturer: FEBEST
- EAN number: 224674175033981750339
- Condition: New
- Control / Trailing Arm Type: Control Arm
- Material: Sheet Steel
- Fitting Position: Rear Axle Left, Lower, Front
- paired article number: 40438
- Supplementary Article / Supplementary Info Info 2: with bolts / screws
- Weight [kg]: 1,325
- Supplementary Article / Supplementary Info: with nuts
- Observe service information
- Bolt / Nut Version: with plain washer, with lockwasher
- Item number: 40439
- Manufacturer: FEBI BILSTEIN
- EAN number: 4027816404392
- Condition: New
These products are designed to be used as originally These products are designed to be used as originally intended and not modified for purpose. Please ensure the intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are installed by a competent individual. N.B. products are usually supplied without fitting instructions. products are usually supplied without fitting instructions.
- Control / Trailing Arm Type: Control Arm
- Fitting Position: Rear Axle, Front, Right
- paired article number: 35464 01
- Article number of recommended accessories: 38823 01
- Item number: 35465 01
- Manufacturer: 尝贰惭贵脰搁顿贰搁
- EAN number: 4047437377394
- Condition: New
- Control / Trailing Arm Type: Control Arm
- Material: Sheet Steel
- Fitting Position: Rear Axle Right
- paired article number: 170517
- Supplementary Article / Supplementary Info Info 2: with bearing(s)
- Weight [kg]: 1,76
- Observe service information
- Item number: 170518
- Manufacturer: FEBI BILSTEIN
- EAN number: 4054224705186
- Condition: New
These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.
- Control / Trailing Arm Type: Trailing Arm
- Material: Sheet Steel
- Fitting Position: Front Axle
- Supplementary Article / Supplementary Info Info 2: with bearing(s)
- Required quantity: 1
- Weight [kg]: 1,74
- Item number: 45050044801
- Manufacturer: VIKA
- EAN number: 224346131572211315722
- Condition: New
- Control / Trailing Arm Type: Control Arm
- Material: Sheet Steel
- Fitting Position: Rear Axle Left, Upper, Rear Axle Right
- Weight [kg]: 1,385
- Supplementary Article / Supplementary Info: with rubber mounts
- Inner Diameter 2 [mm]: 12, 14
- Item number: 30 93 2453
- Manufacturer: SWAG
- EAN number: 4044688587985
- Condition: New
Changed design. Bracket with OE no. 5Q0 614 167 B and 1K0 These products are designed to be used as originally These products are designed to be used as originally 614 167 C (both not included) must be replaced at the same intended and not modified for purpose. Please ensure the intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are installed by a competent individual. N.B. time. products are usually supplied without fitting instructions. products are usually supplied without fitting instructions.
- Control / Trailing Arm Type: Control Arm
- Fitting Position: Rear Axle Left, Rear Axle Right, Upper, Front, outer
- Length [mm]: 304
- Inner Diameter 2 [mm]: 12, 14
- Item number: JTC1401
- Manufacturer: TRW
- EAN number: 3322937990610
- Condition: New
- Control / Trailing Arm Type: Control Arm
- Material: Sheet Steel
- Fitting Position: Rear Axle Right, Lower, Front
- paired article number: 30 94 0439
- Supplementary Article / Supplementary Info Info 2: with bolts / screws
- Weight [kg]: 1,325
- Supplementary Article / Supplementary Info: with nuts
- Bolt / Nut Version: with lockwasher, with plain washer
- Item number: 30 94 0438
- Manufacturer: SWAG
- EAN number: 4044688657152
- Condition: New
These products are designed to be used as originally These products are designed to be used as originally intended and not modified for purpose. Please ensure the intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are installed by a competent individual. N.B. products are usually supplied without fitting instructions. products are usually supplied without fitting instructions.
price incl. 19% VAT
excl. delivery costs
- Control / Trailing Arm Type: Control Arm
- Fitting Position: Rear Axle Left, Rear Axle Right, Upper
- Item number: 1150200800
- Manufacturer: JP GROUP
- EAN number: 5710412428853
- Condition: New
- Control / Trailing Arm Type: Control Arm
- Fitting Position: Rear Axle, Front, Left
- paired article number: 35465 01
- Article number of recommended accessories: 38823 01
- Item number: 35464 01
- Manufacturer: 尝贰惭贵脰搁顿贰搁
- EAN number: 4047437377387
- Condition: New
- Control / Trailing Arm Type: Control Arm
- Material: Sheet Steel
- Fitting Position: Rear Axle Left
- paired article number: 170518
- Supplementary Article / Supplementary Info Info 2: with bearing(s)
- Weight [kg]: 1,76
- Observe service information
- Item number: 170517
- Manufacturer: FEBI BILSTEIN
- EAN number: 4054224705179
- Condition: New
These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.
- Control / Trailing Arm Type: Trailing Arm
- Material: Sheet Steel
- Fitting Position: Front Axle
- Supplementary Article / Supplementary Info Info 2: with bearing(s)
- Required quantity: 1
- Weight [kg]: 1,740
- Item number: 45050045001
- Manufacturer: VIKA
- EAN number: 224346131572221315722
- Condition: New
- Control / Trailing Arm Type: Control Arm
- Material: Sheet Steel
- Fitting Position: Rear Axle Left, Lower, Front
- paired article number: 30 94 0438
- Supplementary Article / Supplementary Info Info 2: with bolts / screws
- Weight [kg]: 1,325
- Supplementary Article / Supplementary Info: with nuts, with rubber mounts
- Bolt / Nut Version: with plain washer, with lockwasher
- Item number: 30 94 0439
- Manufacturer: SWAG
- EAN number: 4044688657169
- Condition: New
These products are designed to be used as originally These products are designed to be used as originally intended and not modified for purpose. Please ensure the intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are installed by a competent individual. N.B. products are usually supplied without fitting instructions. products are usually supplied without fitting instructions.
- Fitting Position: Lower, inner, Rear Axle Right
- paired article number: 510349
- Item number: 510350
- Manufacturer: GSP
- EAN number: 2237398505010
- Condition: New
- Control / Trailing Arm Type: Control Arm
- Fitting Position: Rear, Upper
- Item number: 45050056201
- Manufacturer: VIKA
- EAN number: 224346131572251315722
- Condition: New
- Control / Trailing Arm Type: Control Arm
- Material: Sheet Steel
- Fitting Position: Rear Axle, Upper
- Inner Diameter 2 [mm]: 12, 14
- Item number: 72-1822
- Manufacturer: MAXGEAR
- EAN number: 5907558583014
- Condition: New
- Control / Trailing Arm Type: Control Arm
- Fitting Position: Front Axle Left
- Length [mm]: 465
- Height [mm]: 60
- paired article number: RH04-0079
- Width [mm]: 410
- Thread Size 3: Without Ball Joint
- Item number: RH04-0078
- Manufacturer: REINHOCH
- EAN number: 5901655250015
- Condition: New
- Control / Trailing Arm Type: Control Arm
- Fitting Position: Front Axle Right
- Length [mm]: 465
- Height [mm]: 60
- paired article number: RH04-0078
- Width [mm]: 410
- Thread Size 3: Without Ball Joint
- Item number: RH04-0079
- Manufacturer: REINHOCH
- EAN number: 5901655250022
- Condition: New
- 1
- 2
- 3
- 4
- 5